Table of Contents
Advertisement
278
If and when
Changing the turn signal bulb
The procedure for changing the bulb is the same on both
sides.
– Switch off the ignition and the lights.
– Raise the bonnet.
– Pull the rubber cap
– Remove the bulb holder by pulling on the grip and turning it anti-
clockwise
– Replace the blown bulb in the bulb holder (press and turn anti-
clockwise to remove) with a new bulb (press and turn clockwise
to insert).
– Insert the bulb holder into the socket with the tab facing upwards
and the grip horizontal. Press it against the socket and turn
clockwise. When changing the bulb, you can check the position
of the bulb through the headlight glass.
– Fit the rubber cap and tighten, making sure it fit properly into the
Fig. 218 Turn signal
headlight casing.
– Check whether the new bulb is working.
Fig. 219 Turn signal
⇒ fig. 218
to remove it.
⇒ fig.
219.
Advertisement
Table of Contents
