Configure The Finishing Settings; Set The Océ Finishing Assistant - Oce ColorWave 500 Operation Manual

Configure the Finishing settings

Set the Océ Finishing Assistant
Introduction
This setting is only available when a folder is installed .
The [Océ Finishing Assistant] can automatically detect the legend (if present) of a drawing and
rotate and align the drawing so the legend will be on the cover page of the fold package. If no
legend can be detected the print is delivered unfolded.
When enabled, the [Océ Finishing Assistant] overrules the default rotation and alignment settings
for folded output.
Procedure
1. Open the [Preferences] - [Print job defaults] tab.
2. Click on [Edit] in the [Layout] section, or click the [Océ Finishing Assistant] setting.
3. Select [Enabled] if the printer must automatically detect the legend of your drawings and fold the
drawings correctly.
4. Click [Ok] to confirm, or [Cancel] to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools
Configure the Finishing settings
129