The Take-Up Module (Optional); Configure The Roll-To-Roll Mode - Oce ColorWave 500 Operation Manual

The take-up module (optional)

The take-up module (optional)
Introduction
The Océ ColorWave 500 is compatible with the optional take-up module.
The take-up module allows the user to print in Roll-to-roll mode. The module rolls up your print
jobs automatically on a core without cutting. This can be handy when you want to transport your
prints or want to automatically clean-cut or trim your prints, laminate or mount an adhesive back
to the prints.
Before you can use the take-up module, you must first set the printer into the Roll-to-roll mode.
You can enable the Roll-to-roll mode in Océ Express WebTools and on the user panel, see
Configure the Roll-to-roll mode in Océ Express Webtools on page 121
roll mode on page
By default, the printer is delivered in Roll-to-sheet mode. In this mode, the machine cuts and
delivers each print to the selected delivery destination.

Configure the Roll-to-roll mode

Introduction
When you want to use the take-up unit, your printer has to be in the Roll-to-roll mode. When you
enable the Roll-to-roll mode, the printer will not cut between pages. You can also configure the
Roll-to-roll mode in Océ Express Webtools.
NOTE
• When the Roll-to-roll mode is enabled, each print job is delivered to the [Back output]; even
when you set the [Top delivery tray] as output location for your prints.
• To calibrate the printer the Roll-to-roll mode must be disabled.
Procedure
1. Tap on the system menu thumbnail. The system menu opens.
2. Tap on [Roll-to-roll option] in the list in the right part of the display.
3. Log in as a Key operator.
4. Select [Roll-to-roll disabled] or [Roll-to-roll enabled].
5. Tap [Ok] to confirm, or [Cancel] to reject your entries.
40 Chapter 2 - Get to Know the Printing System
40.
Configure the Roll-to-
and