The Delivery Destination - Oce ColorWave 500 Operation Manual

The delivery destination

Introduction
The Océ ColorWave 500 is delivered with a [Top Delivery Tray (TDT)] to collect your printed
output.
The [Top Delivery Tray (TDT)] can collect 50 - 100 plain paper prints with a maximum length of
1200 mm, 48 inch. The media type you use influences the output capacity.
In Océ Express WebTools you can define the default [Print delivery] for your printed output. To
set the default [Print delivery], select the [Preferences] - [Print job defaults] tab.
• If you use 2 inch media cores instead of the standard 3 inch media cores, the printed output is
automatically delivered at the back of the printer. The installation of one of the finishing
options is then advised.
• Some media require a specific output delivery. For example heavy media or media that
requires a manual cut can automatically be delivered at the back of the printer. This is defined
in the properties of the media type.
• If you select [Top Delivery Tray (TDT)] your printed output is by default delivered in the
standard [Top Delivery Tray (TDT)].
• If you select [Back output] your printed output is by default delivered at the back of the printer.
In that case you can expand your printer with one of the following finishing options.
The finishing options
Select the finishing device configuration on page 37
See also
Chapter 2 - Get to Know the Printing System
The delivery destination
35