Osc Edit Switch (Osc 2); Osc 2 Menu - Behringer DEEPMIND 12 User Manual

61 DeepMind 12 User Manual
• • LFO-1 - Bipolar use of the LFO 1 waveform. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
• • LFO-2 - Bipolar use of the LFO 2 waveform. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
OSC 1 PULSE WIDTH MODULATION (LFO AS SOURCE)
OSC 1 (SQR)
LFO (SIN)
PWM
Note: When an LFO is used as a PWM source, the arrows indicate the range of
modulation as shown below:
ENV-1 - Unipolar use of the ENV 1 envelope. In this mode the PWM fader is
• •
used to adjust the amount of modulation from 0 to +/- 49%.
• • ENV-2 - Unipolar use of the ENV 2 envelope. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
• • ENV-3 - Unipolar use of the ENV 3 envelope. In this mode the PWM fader is
used to adjust the amount of modulation from 0 to +/- 49%.
OSC 1 PULSE WIDTH MODULATION (ENVELOPE AS SOURCE)
OSC 1 (SQR)
ATTACK DECAY
ENVELOPE
PWM
Note: When an ENVELOPE is used as a PWM source, the arrows indicate the range
of modulation as shown below:.
RELEASE
SUSTAIN
P.MOD MODE - This option allows you to select which oscillators are controlled
by the OSC 1 PITCH MOD fader.
Note: It is useful to have both OSCs responding for eff ects like tremolo.
• • OSC1+2 -Both OSCs have PITCH MODULATION applied to them.
• • OSC1 - Only OSC 1 has PITCH MODULATION applied to it.
KEY-DN-RESET - This option allows you to reset the phase of oscillator waveform
to start from its reset point each time a key is pressed.
OSC 1 KEY DOWN RESET
OSC 1 (SAW)
KEY-DN-RESET
OFF
KEY-DN-RESET
ON
KEY PRESS KEY PRESS
The default setting for KEY-DN-RESET is Off .
To exit the OSC EDIT menu press the PROG switch to return the main display, or to
continue to the OSC 2 EDIT menu press the OSC EDIT switch again.

8.3.13 OSC EDIT SWITCH (OSC 2)

To access the OSC EDIT menu press the OSC EDIT switch.
FLASHING=EDIT
The OSC EDIT switch will then start fl ashing and the OSC 1 EDIT menu is then
shown. Press the EDIT switch again to show the OSC 2 EDIT menu:
To navigate the options in the OSC 2 EDIT menu, use the UP, DOWN, switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range.

8.3.14 OSC 2 MENU

The following options are available in the OSC 2 EDIT menu:
RANGE - This option allows you selects the base pitch of the OSC as follows:
16' - The lowest note on the keyboard (C) is tuned to 16.35 Hz.
8' - The lowest note on the keyboard (C) is tuned to 32.7 Hz.
4'- The lowest note on the keyboard (C) is tuned to 65.4 Hz.
The default setting for the RANGE is 8'.
KEY PRESS