Arp Rate Fader; Arp Gate Time Fader - Behringer DEEPMIND 12 User Manual

40 DeepMind 12 User Manual

8.1.5 ARP RATE FADER

The RATE fader controls the Master BPM RATE of the ARPEGGIATOR. The Master
BPM is used by the ARPEGGIATOR, CONTROL SEQUENCER and is also used in any
parameters which can be linked to the Master BPM, such as the LFO, Envelopes
and some Eff ect parameters.
Decreasing the value will make the Master BPM RATE slower, and increasing the
value will make the Master BPM rate faster as shown below:
MASTER BPM (RATE)
FAST
MED
SLOW
The Master BPM RATE range is from 20.0 to 275.0 BPM. The default Master BPM
RATE value is 120.0 BPM.
The fader position, current value and stored value for the ARP RATE fader is
shown on the PROG screen. There is also a visualization of the ARP RATE as
shown below:

8.1.6 ARP GATE TIME FADER

The GATE TIME fader controls the length of the note as shown below.
With the fader in the middle position, the GATE TIME is equally split so that the
note length is exactly half of a step. Decreasing the value will make the GATE
TIME shorter, and increasing the value will make the GATE TIME longer as shown
below:
GATE TIME
LONG
EQUAL
SHORT
Note: The GATE TIME FADER on the front panel, and the GATE TIME PARAMETER in
the PATTERN EDITOR both aff ect the length of the notes.
With the GATE TIME FADER at maximum the note length matches the full length
of the PATTERN GATE TIME.
When the GATE TIME fader is in the middle then the note length is half of the
PATTERN GATE TIME.
The GATE TIME range is from 0 to 255, with 0 being no note and 255 being a full
note. The default GATE TIME value is 128, which represents half of a step.
The fader position, current value and stored value for the ARP GATE TIME fader is
shown on the PROG screen. There is also a visualization of the ARP GATE TIME
period, using the width of two consecutive notes as shown below: