Curves Switch; Mod Envelope Switch - Behringer DEEPMIND 12 User Manual

75 DeepMind 12 User Manual

MOD ENVELOPE SWITCH

To access the MOD ENVELOPE page press the MOD ENVELOPE switch.
FLASHING=EDIT
The MOD ENVELOPE switch will then start fl ashing and the MOD ENVELOPE menu
is then shown:
To navigate the options in the MOD ENVELOPE menu, use the UP, DOWN, switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range:
The following options are available in the MOD ENVELOPE menu:
MOD-ENV-TRIG - This option allows you to select the triggering mode for the
MOD ENVELOPE from the following:
• • Key - This option will force the envelope to be triggered each time a key is
pressed.
• • LFO-1 - This option will force the envelope to be triggered each time LFO 1
starts a new cycle.
• • LFO-2 - This option will force the envelope to be triggered each time LFO 2
starts a new cycle.
• • Loop - This option will force the envelope to be re-triggered each time the
end of the release stage is reached.
• • Seq - This option will force the envelope to be re-triggered on every step of
the CONTROL SEQUENCER.
ADSR ATK: - This controls the attack time of the MOD envelope. I.e. the time is
take for the envelope to reach its peak setting. As the value increases, the slower
the attack time becomes and the longer it takes for the envelope to reach its
maximum point.
ADSR DCY: This controls the decay time of the MOD envelope. After the envelope
reaches the maximum value, the decay time controls how quickly the envelope
will transition to the sustain level. As the value increases, the longer the decay
time becomes.
ADSR SUS: This controls the value for the sustain stage of the MOD envelope. The
sound will stay at this level while a note is held on the keyboard.
ADSR REL: This option control the release time of the MOD envelope. This
controls how quickly it takes the envelope to decay from the sustain value to zero
when a key is released.

8.8.3 CURVES SWITCH

ON=CURVES
This switch changes the operation of the ADSR faders from adjusting the ADSR
stages to adjusting the curve of each stage.
To activate CURVES mode press the CURVES switch. The switch will illuminate and
the faders will now control the curve of each stage.
ENVELOPE CURVES
ATTACK
DECAY
SUSTAIN
CURVE
CURVE
CURVE(SLOPE)
CURV ATK: This controls the curve shape of the attack stage.
CURV DCY: This controls the curve shape of the decay stage.
CURV SUS: This controls the curve shape (or slope) of the sustain stage.
CURV REL: This controls the curve shape of the release stage.
Using the curve functionality of the waveforms allows advanced sculpting of any
of the envelopes. An example is shown below:
Note: When you adjust any of the envelope faders while viewing the PROG screen
you will see a visualization of the envelope. Below the visualization you will see
the standard or curve parameter values as shown below:
To return to normal operation of the ADSR stages press the CURVES switch again.
The switch will no longer illuminate and the faders will now control the ADSR
stages.
RELEASE
CURVE