Backup; Calibrate Pedal - Behringer DEEPMIND 12 User Manual

33 DeepMind 12 User Manual

CALIBRATE PEDAL

To calibrate the PEDAL please use the following process:
Note: During the calibration the GLOBAL, -NO and +/YES switches will be
fl ashing. If at any time you want to cancel the calibration routine, you can press
the -/NO switch. No previous calibration data will be changed if you do cancel the
routine. To confi rm the calibration at each stage press +/YES as described below.
In order to start the calibration routine make sure that the ' < ' symbol on the CAL
CALIBRATE PEDAL line is highlighted and press +/YES.
You will see the following display showing a bar representing the current PEDAL
value (0% for no pressure). Also on this screen you can see the stored calibration
data above the bar and the current value below the bar:
Then press the pedal until the value stops increasing.
You will see the following display showing the maximum position of the PEDAL
input and the associated value:
Note: To cancel the any routine you can press the -/NO switch, you will see the
following message:
To confi rm the CALIBRATION of the PEDAL input press the +/YES switch: The
calibration data will then be stored for the PEDAL and you will be returned to the
CALIBRATE menu. From here you can perform another calibration from the menu,
or press the GLOBAL switch again to return to the SYSTEM SETTINGS menu.
7.2.17 BACKUP (backup Menu)
The last item in the SYSTEM SETTINGS menu is BACKUP.
Pressing +/YES when "BACKUP -->" is selected, will bring up the BACKUP MENU.
(The "RESTORE BANK" lines only appear after the fi rst backup is done).
Pressing /YES when "BACKUP PROGRAMS" is selected, will bring up a
confi rmation dialog:
Pressing YES again, copies all Banks of programs from EEPROM to fl ash, and
overwrites the "factory default" data.
Pressing +/YES when any of the RESTORE-BANK-A to RESTORE-BANK-H lines is
selected, will bring up a confi rmation dialog:
Pressing YES again will restore the selected bank from fl ash.