Behringer DEEPMIND 12 User Manual page 95

95 DeepMind 12 User Manual
NoiseGate (NOISE GATE)
No DM12 REF PARAMETER
1* THR Threshold
2 RNG Range
3* ATT Attack
4* REL Release
5* HLD Hold
6 PUN Punch
7 MOD Mode
8 PWR Power
Delay (STEREO DELAY)
No DM12 REF PARAMETER
1* MIX Mix
2 TIM Time
3 MOD Mode
4 FCL FactorL
5 FCR FactorR
6 OFS Off set
7* LC LC
8* HC HC
9* FLC FeedLC
10* FBL FeedL
11* FBR FeedR
12* FHC FeedHC
UNITS MIN MAX
dB -50.0 0.0
dB -100.0 0.0
ms 0.0 20.0
ms 2.0 1999.9
ms 2.0 1999.9
— -6.0 6.0
— — —
— ON OFF
UNITS MIN MAX
% 0.0% 100%
ms 1.0 ms 1500.0 ms
— — —
— — —
— — —
ms -100.0 ms 100.0 ms
Hz 10.0 Hz 500.0 Hz
Hz 200.0 Hz 20000.0 Hz
Hz 10.0 Hz 500.0 Hz
% 0.0% 100%
% 0.0% 100%
Hz 200.0 Hz 20000.0 Hz
DESCRIPTION
Sets signal level at which gate opens.
Control adjusts the amount of gain reduction applied to the signal below threshold.
Adjusts time taken for gate to open after an over-threshold signal.
Adjusts time taken for gate to close after programme material falls back below threshold.
This defi nes a waiting period before the gate starts to close.
Used to increase tonal shaping or reduce gated breathing/delay/resonant howl-round.
GAT (Gate), TRN (Transient Gate), DUC (Ducker).
Enables gate in the signal path. When switched off , gate is bypassed.
DESCRIPTION
Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
Adjusts the master delay time. Time synchronised options from 4 to 1/64 bars.
S- Stereo feedback, X - crosses feedback between channels, M - Mono mix in feedback chain.
Sets left delay to rhythmic fractions of the master delay (1/4, 3/8, 1/2, 2/3, 1, 4/3, 3/2, 2, 3).
Sets right delay to rhythmic fractions of the master delay (1/4, 3/8, 1/2, 2/3, 1, 4/3, 3/2, 2, 3).
Adds a delay diff erence between the left and right delayed signals.
Adjusts the low frequency cut, allowing lower frequencies to remain unaff ected by the delay.
Adjusts the high frequency cut, allowing higher frequencies to remain unaff ected by the delay.
Adjusts the low cut fi lter frequency in the feedback paths.
Control the amount of feedback for the left channel.
Control the amount of feedback for the right channel.
Adjusts the high cut fi lter frequency in the feedback paths.