Write (Write Menu) - Behringer DEEPMIND 12 User Manual

35 DeepMind 12 User Manual

7.4 WRITE (Write Menu)

To write a program to memory press the WRITE switch to open the WRITE
PROGRAM menu.
The WRITE PROGRAM menu will then appear:
In this menu you can use the -NO/+YES switches to navigate through the
sections. The selected section will be highlighted by an inverted character (white
on black).
The fi rst section is the program location the current program will be saved.
You can use the UP/DOWN switches, the rotary knob, or the fader to select the
required BANK (A-H) and PROGRAM NUMBER (1-128).
The second section is the CATEGORY to select any of the available categories.
Again you can use the UP/DOWN switches, the rotary knob, or the fader to select
the required CATEGORY.
The third section is REPLACED BY which allows you to name the program to be
written. You can use the -NO/+YES switches to step through each character of the
name and use the UP/DOWN switches, the rotary knob, or the faders to change
the character.
There are also two short-cuts for selecting characters indicated by text above the
FX and GLOBAL switches:
a-A-0 - Pressing the FX switch will cycle between lower-case, upper-case and
numbers.
DEL - Pressing the GLOBAL switch will delete the currently selected character.
Note: These short-cuts only appear when you are editing the name of the
REPLACED BY program.
To compare the current program with the intended program location you can
press the COMPARE switch to listen to the diff erence. To return to the current
program, press the compare switch again.
Once you have selected the new location and named the program simply press
the WRITE switch again to write the program.
At anytime you decide you do not want to write the program, you can press the
PROG switch to return to the main programming display. Note: If there is a
program in the backup memory then you will see the message "COMPARE to clear
backup".
If you wish to listen to the intended program location as described earlier you will
need to press the COMPARE switch to clear the backup memory. Once the backup
has been cleared then the message will revert to "COMPARE to listen" and you
can listen to the intended program location as normal.
7.5 Re-naming Programs
To rename a program simply follow the procedure for writing a program and
keep the BANK and PROGRAM NUMBER the same.