Poly Edit Switch; Voice Parameters Menu - Behringer DEEPMIND 12 User Manual

64 DeepMind 12 User Manual
The fader position, current value and stored value for the UNISON DETUNE fader is
shown on the PROG screen. There is also a visualization of the detuning amount
as shown below:

8.4.2 POLY EDIT SWITCH

To access the POLY EDIT menu press the POLY EDIT switch.
FLASHING=EDIT
The POLY EDIT switch will then start fl ashing and either the VOICE PARAMETERS
or PITCH PARAMETERS menu is then shown (depending on what you had last
worked on, as the location is remembered.

8.4.3 VOICE PARAMETERS MENU

This is the VOICE PARAMETERS menu:
To navigate the options in the VOICE PARAMETERS menu, use the UP, DOWN,
switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range:
Note: At this point if you wish to access the PITCH PARAMETERS menu, press the
EDIT switch again.
The following options are available in the VOICE PARAMETERS menu:
POLYPHONY - This allows you to choose how the DeepMind 12 voices are
allocated from one of the following options:
• • Poly - A single voice is allocated to each note.
• • Unison-2 - The next available two voices are allocated to each note played.
Detuning is applied as shown below:
UNISON 2
UNISON 2
WAVEFORM
1
UNISON 2
SPECTRUM
MAX -VE
DETUNE
Unison-3 - The next available three voices are allocated to each note played.
Detuning is applied as shown below:
UNISON 3
UNISON 3
WAVEFORM
1
UNISON 3
SPECTRUM
MAX -VE
DETUNE
• • Unison-4 - The next available four voices are allocated to each note played.
Detuning is applied as shown below:
UNISON 4
UNISON 4
WAVEFORM
1 2
UNISON 4
SPECTRUM
MAX -VE
DETUNE
ROOT NOTE
FREQUENCY
2
MAX +VE
DETUNE
ROOT NOTE
FREQUENCY
2 3
MAX +VE
DETUNE
ROOT NOTE
FREQUENCY
3 4
MAX +VE
DETUNE