True analog 12-voice polyphonic synthesizer with 4 fx engines, 2 oscs and lfos per voice, 3 adsr generators, 8-channel modulation matrix, 32-step sequencer, tablet remote control and built-in wifi (18 pages)
Paraphonic analog and semi-modular synthesizer with dual 3340 vcos,
multi-mode vcf, 2 adsrs, bbd delay and overdrive circuit in a eurorack format (30 pages)
Summary of Contents for Behringer MODEL D
Page 1
User Manual MODEL D Legendary Analog Synthesizer with 3 VCOs, Classic Ladder Filter, LFO, 16-Voice Poly Chain and Eurorack Format...
Page 2
9. Specifications ............34 10. Glossary ..............36 Thank you Thank you very much for expressing your confidence in BEHRINGER products by purchasing the MODEL D analog synthesizer - with 3 VCOs, Classic Ladder Filter, LFO, 16-Voice Poly Chain and Eurorack Format...
TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, the apparatus. When a cart alerts you to the presence of uninsulated BEHRINGER, BUGERA and COOLAUDIO are trademarks is used, use caution when dangerous voltage inside the or registered trademarks of MUSIC Group IP Ltd.
MODEL D User Manual About the MODEL D • Legendary analog synthesizer with triple VCO design allows for insanely fat music creation • Authentic reproduction of original “D Type” circuitry with matched transistors and JFETs • Ultra-high precision 0.1% Thin Film resistors and Polyphenylene Sulphide capacitors •...
It meets the required safety standards. Do not use any other power adapter. MODEL D’s Filter Mode switch can be set to either Lo- or Hi-pass for selecting the range of your choice. You can also adjust the Attack, Decay, and Sustain controls WARNING: Please make sure that all units have a proper ground to affect the cutoff frequency with time.
Page 6
USB – and start exploring the world of analog music synthesis right out-of- the-box. Eurorack Ready Designed to handle the rigors of life on the road or in the studio, your MODEL D can easily be transferred into a standard Eurorack case for the perfect integration into your existing system.
MODEL D User Manual 3. Controls 3.1 Top Controls (2) (3) (17) (18) (19) (26) (27) (28) (29) (25) (24) (23) (10) (11) (12) (13) (14) (15) (16) (20) (21) (22) (37) (38) (39) (40) (41) (48) (49) (33) (32)
Page 8
(28) (29 (1) USB PORT - this USB type B jack allows connection to a computer. The MODEL D will show up as a class-compliant USB MIDI device, capable of supporting MIDI in and out. USB MIDI IN - accepts incoming MIDI data from an application.
Page 10
MODEL D User Manual 3.1.5 Modifiers Section FILTER ENVELOPE CONTROLS - these 3 knobs adjust the overall shape (35) (12) (13) (14) (15) (16) (20) (21) (22) enveloping the filter section. The controls affect the change in cutoff frequency with time.
If you are using the MODEL D in a Eurorack, then this is the main output, as the rear panel DC INPUT - connect the supplied 12V DC power adapter here. The power (53) output connectors are not used.
A quick way of finding out if your external sound system is working, is to turn on the A-440 switch on the MODEL D and adjust the volume control. This will send a constant tone (440 Hz) to your external amplifier and speakers.
SysEx commands shown later in this manual. Only set the Poly Chain ON for the first MODEL D. Turn it OFF if you no longer 4.9 Special Modes require a Poly Chain system.
A-440 Reference The MODEL D A-440 pitch is generated and regulated by the MCU and there is no adjustment required. This set frequency is used as a reference in the following procedure to calibrate OSC1.
Page 16
16. Turn on the MODEL D rear panel power switch and check that its Power LED comes on. 17. Do not turn off the MODEL D or let it cool down, until all the calibrations are completed. 18. If the A-440 switch is in the ON position, you should hear the tone in your heaphones or main system if you carefully bring the headphone volume or main volume up.
Page 17
MODEL D User Manual The diagram below shows the Test Points TP1 and TP2 used in the PITCH/CV calibration. Take a look at the PCB and locate these two test points. DC Voltmeter DC Voltmeter 0.001 The diagram below shows the adjustment trimpots that are used in the Oscillator and Octave range calibration procedures.
Page 18
The following example shows the use of the popular MIDI Utility "MIDI OX" to send a SysEx message from your computerto the MODEL D to put it into PITCH CV Calibration mode. (This same procedure can be used to send any SysEx message to the MODEL D.)
Page 19
9. Then use the LOAD command in the Command Window drop down menu to recall the SysEx message from a file on your computer. 7. The SysEx message will be sent to the MODEL D, and it will then be in its PITCH Calibration mode.
Page 20
MODEL D User Manual Pitch CV Calibration continued 5.2.2 Procedure 1. Follow the procedure on the previous page to put the MODEL D into PITCH Calibration mode using SysEx. 2. Make sure that the preliminary procedures shown in section 5.1 have been followed, and the MODEL D front panel controls and switches are set as directed.
Page 21
C3 = decrement coarse 20. If you do not want to do any other calibrations, turn off the MODEL D, check the internal cables are securely connected, and secure its front panel D3 = decrement fine assembly back onto the chassis using the 8 screws.
Page 22
MODEL D User Manual 5.3 Oscillator Calibration The oscillator calibration is done by following 3 main procedures: OSC1, OSC2, and OSC3. Each procedure is slightly different. OSC1 is calibrated by referring to the A-440 test tone, then OSC2 is calibrated against OSC1, and OSC3 is also calibrated against OSC1.
Page 23
7. Turn OFF the A-440 switch. 24. If you do not want to do any other calibrations, turn off the MODEL D, 8. Make sure the OSC1 switch is left ON for the next calibration.
Page 24
This calibration is done after the oscillator calibration. OSC1 ON 1. Make sure that the preliminary procedures shown in section 5.1 have been followed, and the MODEL D front panel controls and switches are set as directed. OSC1 Max 2.
Page 25
Octave RANGE knob. 12. This completes the Octave Range Calibration. 13. If you do not want to do any other calibrations, turn off the MODEL D, check the internal cables are securely connected, and secure its front panel assembly back onto the chassis using the 8 screws.
MODEL D User Manual 6. Hook-up examples 6.1 Studio System MIDI Keyboard MIDI OUT USB B MIDI IN USB B Power Adaptor Audio Interface USB A USB A Headphones Desktop Computer Studio Monitors...
Page 27
MODEL D User Manual 6.2 Band / Practice System MIDI Keyboard MIDI OUT Footswitch MIDI IN Expression Pedal Headphones Power Adaptor Keyboard Ampli er...
Page 28
MODEL D User Manual 6.3 Live System MIDI Keyboard MIDI OUT USB A Laptop Computer Footswitch MIDI IN USB B Expression Pedal Headphones Power Adaptor Mixing console Active Loudspeakers...
Poly Chain If you have multiple MODEL D units, you can connect them in a Poly Chain as shown, so that the first MODEL D plays the lowest note, the second MODEL D plays the second lowest note, and so on, to produce polyphonic sound.
You have to use SysEx to set the Poly Chain ID of the first MODEL D to Device ID=0, the second MODEL D to ID=1, the third MODEL D to ID=3 and so on. All MODEL D units must have the same MIDI channel.
Page 31
MODEL D User Manual 7.3 Command Examples Note: All command parameters should be in hexadecimal format. Function SysEX Command String Set MIDI Channel to 13 F0 00 20 32 00 7F 0A 00 00 0C F7 Set Key Priority to last...
The Eurorack case will need its own suitable power supply unit to power the MODEL D synthesizer. A 10-pin connector on the rear of the main PCB of the MODEL D allows the +12 Pins 1 and 2 VDC power supply connection to be made. A 10-pin to 16-pin adapter ribbon No Connection cable is supplied to connect to your power supply.
Page 33
The MIDI channel can be changed using MIDI OX or a similar MIDI utility on your computer to send MIDI SysEx commands directly to the MODEL D via the USB MIDI connection. Here is a brief guide to the procedure (see the MIDI SysEx pages in this manual for the actual SysEx codes sent to the MODEL D): 1.
MODEL D User Manual 9. Specifications Synthesizer Architecture Filter Section Knobs Cutoff frequency: -4 to +4 Number of voices Monophonic Filter emphasis: 0 to 10 Type Analog Amount of contour: 0 to 10 Oscillators 3 (0.1 Hz to 20 kHz in 6 overlapping ranges) Attack: 1 ms to 10 s Decay: 4 ms to >35 s...
MODEL D User Manual 10. Glossary Cross-Modulation (X-Mod): Two oscillators modulating each other at the same time. The outputs is a mix of the sum and difference of the oscillators. The term This glossary provides an explanation of useful symbols, terms and abbreviations.
Page 37
MODEL D User Manual Effect: One of a number of audio processes that can be applied to a signal to Keyboard: A range of keys, arranged in order of ascending pitch, which enables modify it, such as reverb, flanging, phasing, delay etc.
Page 38
MODEL D User Manual Monitors: Studio quality loudspeakers, providing an accurate representation of Polyphony: The number of notes a polyphonic synthesizer can play the audio signals. simultaneously. Mono: A single signal. Portamento: An adjustable performance effect that glides or bends the pitch from one note to the next.
Page 39
MODEL D User Manual Slew Rate: The rate of change of a voltage or control signal. Unison: Two or more voices that are playing together at roughly the same pitch. Spectrum: First used to describe the full range of colors in visible light, the term Universal Serial Bus (USB): A "plug and play"...
Page 42
MODEL D User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION MODEL D MUSIC Group Services NV Inc. Responsible Party Name: 5270 Procyon Street Address: Las Vegas, NV 89118 +1 702 800 8290 Phone Number: MODEL D complies with the FCC rules as mentioned in the following paragraph: This equipment has been tested and found to comply with the limits for a Class B...
Need help?
Do you have a question about the MODEL D and is the answer not in the manual?
Questions and answers