Behringer DEEPMIND 12 User Manual page 37

37 DeepMind 12 User Manual
CHORD PROGRAMMING - To program a chord, press the CHORD switch (or the
RECORD soft switch if replacing an existing chord). The CHORD switch will begin
double fl ashing and you will then see the screen with the message "Armed" as
shown below:
While the message "Armed" is shown, hold the keys of the chord down and you
will then see the screen with the message "Learning" below:
At this point you can add additional notes to the chord. Once you have all the keys
required held down simultaneously you can release them all. The chord will then
be ready to be assigned and the CHORD switch will fl ash slowly.
Note: The CHORD size is limited to 12 notes.
You will see a message to "Press Trigger" as shown below:
Now press the root note key for the chord to be transposed up or down from.
Once you press a key, the chord you played will have its root note assigned to that
key. The CHORD switch will then stay illuminated (no fl ashing) and the CHORD
mode will be active for the entire keyboard (including any OCTAVE shift applied).
Note: In CHORD mode you can only play one key/CHORD at a time. I.e. when you
hold a key down then press another key, the CHORD will be played from the last
pressed key only.
The screen will now show the following:
2X FLASHING FAST
Now playing any key on the keyboard will play the CHORD you have programmed.
The CHORD will be transposed from the root note to the key that you are playing.
RECORDING A NEW CHORD - To record a new chord (and overwrite the exisiting
chord), press the RECORD soft switch. The existing chord will be deleted and you
will see the message "Armed" indicating that the synthesizer is ready to program
a new CHORD.
DELETING THE CHORD - To delete the chord press the DELETE soft switch. The
chord will be deleted and you will see the message "Armed" indicating that the
synthesizer is ready to program a new CHORD.
2X FLASHING FAST
EXITING THE CHORD SCREEN - Press the EXIT soft switch to exit the CHORD
page. This will return you to the PROG screen but CHORD mode will still be active
and the CHORD switch will be illuminated.
EXITING CHORD MODE - Press the CHORD switch again to turn off CHORD MODE,
the switch will no longer be illuminated.
Note: When the keyboard local control is on, all chords will be sent to any
connected devices. When keyboard local control is off only the trigger note
will be sent to any connected devices. When the trigger notes are received the
FLASHING SLOW
DeepMind 12 will play respective chords based on incoming trigger notes.
ILLUMINATED
2X FLASHING FAST