Pedal Settings - Behringer DEEPMIND 12 User Manual

28 DeepMind 12 User Manual
VEL CURVE - You can adjust the response curve for the VELOCITY here. The Hard
setting will reduce the dynamic range of played notes. The Soft setting will
increase the dynamic range of played notes.
Velocity Sensitivity Curve Settings
Hard
Med
Slow
Strike Speed
The default setting is Soft.
AFT-CURVE - You can adjust the response curve for the AFTERTOUCH here. The
Hard setting will reduce the dynamic range of key pressure. The Soft setting will
educe the dynamic range of key pressure.
AfterTouch Sensitivity Curve Settings
Hard
Med
Soft Key Pressure
The default setting is Soft.
Note: The DeepMind 12 keyboard sends "Channel Aftertouch", meaning the MIDI
message created is common to all keys.
WHEEL-LEDS - Both the PITCH WHEEL and the MODULATION WHEEL have the
possibility to be illuminated, depending on your requirements. You can control
the illumination mode here by selecting one of the following options:
Auto - In this mode, the illumination will get brighter as the respective wheel is
moved, reaching its brightest point at the end of its travel.
On - In this mode the illumination is fi xed on.
Off - In this mode the illumination is turned off .
The default setting is Auto.
To exit this menu press the PROG switch to return to the main
programming screen, or press GLOBAL to cycle to the PEDAL SETTINGS menu.
Soft
Fast
Soft
Hard

7.2.13 PEDAL SETTINGS

In this menu there are all the settings relating to PEDAL/CV and SUSTAIN inputs
on the rear of the DeepMind 12.
To navigate the options in the PEDAL SETTINGS menu, use the UP and DOWN
switches.
In order to change any of the parameters make sure that the ' < ' symbol on the
respective line is highlighted.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range.
PEDAL/CV - This option allows you to choose the PEDAL/CV MODE from the
following options:
The PEDAL/CV input can work with a typical foot pedal, where the voltage is
supplied by the DeepMind 12 and fed back at a level which is dependant on the
position of the pedal. The further the pedal is pressed, the higher the voltage.
The PEDAL/CV input can also work with a CV (Control Voltage) input
from any source with a 0 to +5V output e.g. the Control Voltage from a
modular synthesizer.
Note: For wiring diagrams and pin connections information please consult the
guide later in this document.
The PEDAL input takes the voltage from the connector and turns it into a control
signal. The control signal can be mapped to any of the following:
Foot-ctrl - The Foot-Ctrl (Foot Controller) is available as a modulation source
• •
in the MOD MATRIX.
• • Mod-Wheel - Here the PEDAL input is mapped to the MODULATION WHEEL
which is available as a modulation source in the MOD MATRIX.
• • Breath - Here the PEDAL input is mapped to the BREATH controller which is
available as a modulation source in the MOD MATRIX.
• • Volume - Here the PEDAL input is mapped to the VOLUME controller.
• • Expression - Here the PEDAL input is mapped to the EXPRESSION controller.
The default setting is Foot-ctrl.
SUSTAIN - This option allows you to choose the SUSTAIN MODE from the
following options:
The SUSTAIN input can work with a switched input which is either open when
pressed, or closed when pressed.