Noise Level Fader; Osc Edit Switch (Osc 1); Osc 1 Menu - Behringer DEEPMIND 12 User Manual

59 DeepMind 12 User Manual
Note: If OSC 2 is lower than 1/2 of the frequency of OSC 1 then there will be no
output from OSC 2 when SYNC is ON because the waveform will never reach its
negative cycle.
The OSC SYNC option can be On/Off . The default program setting is Off .
There is also a visualization of the SYNC waveform as shown below

8.3.10 NOISE LEVEL FADER

The NOISE LEVEL fader controls the LEVEL of the NOISE signal.
The noise generator is implemented using analog circuitry and creates pink
noise with a low frequency roll-off designed specifi cally for the DeepMind 12.
The noise generator is commonly used with non-pitched sounds or non-pitched
components of a sound e.g. a snare drum or an atmospheric sound.
Pink noise contains equal amounts of energy in each octave. As human hearing is
roughly logarithmic, this type of noise sounds as if it has an equal amount of all
frequencies and produces a rushing sound similar to that of a waterfall.
The NOISE LEVEL can be set to Off , or its operational range is from -48.1 dB to
0.0 dB. The default NOISE LEVEL setting is 0ff .
The fader position, current value and stored value for the NOISE LEVEL fader is
shown on the PROG screen. There is also a visualization of the noise signal as
shown below:

8.3.11 OSC EDIT SWITCH (OSC 1)

To access the OSC EDIT menu press the OSC EDIT switch.
FLASHING=EDIT
The OSC EDIT switch will then start fl ashing and the OSC 1 EDIT menu
is then shown:
To navigate the options in the OSC 1 EDIT menu, use the UP, DOWN, switches.
Selected parameters are adjusted using the -NO/+YES switches, the rotary knob
or the fader. The rotary knob has a click which allows very accurate control. The
fader allows rapid adjustment across the full range:
Note: At this point if you wish to access the OSC 2 EDIT menu, press the EDIT
switch again.
Shortcut Note: To change any of the OSC Modulation sources press and hold the
OSC EDIT switch. While holding the switch you can use any of the following faders
to set the source for the respective parameter

8.3.12 OSC 1 MENU

The following options are available in the OSC 1 EDIT menu:
RANGE - This option allows you selects the base pitch of the OSC as follows:
16' - The lowest note on the keyboard (C) is tuned to 16.35 Hz.
8' - The lowest note on the keyboard (C) is tuned to 32.7 Hz.
4'- The lowest note on the keyboard (C) is tuned to 65.4 Hz.
The default setting for the RANGE is 8'.