AGFEO basic-line plus AS 140 Operation And Program Manual page 209

- Copy the unpacked files into the "Up-
dates" subdirectory of the TK-Soft direc-
tory on your hard disk (by default: under
"C:\TKSoft").
- Start the "TK-Flash" update program (by
default: in the "C:\TKSoft" directory).
Refer to the online help for details of how
to operate "TK-Flash".
The new software is now loaded into the
Clearing the memory from a system telephone* ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
!9#
Initiate the function. Pay attention to the dis-
play: if the setup code is prompted after you
press the key 9, you must enter the code as
four digits.
&&
"next": moves you to the "clear memory"
...
menu.
$
"enter": initiates clearing of the memory (the
system is reset to the "as-delivered" settings);
this is followed by a safety prompt.
$
"enter": confirms clearing of the memory if
you really wish to clear it.
The memories are cleared (approximately 2
minutes). (All data is deleted and program-
ming is ended automatically.)
Deleting the memory (analog terminals / ISDN terminals) ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
The programming mode must be started with
h PS709
Lift handset Delete memory (reset to the
as-delivered state)
The memory is deleted.
Loading the telecommunications system's system data ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
Copy the stored system data back from the
PC into the telecommunications system.
S
* Use -procedure on the ST 25 of AS 141, AS 191
telecommunications system. You cannot
make any telephone calls during the load
operation (approximately 5 minutes). You
can observe the load process on the PC's
monitor.
- End "TK-Flash".
- Clear the telecommunications system's
memory from the system telephone or
from an a/b telephone.
h ª
Q
S705
Q Pª
Acknowledge tone Replace handset
The telecommunications system now oper-
ates with the new software
3
Programming
Versionsnummer
ansehen
Speicher löschen
enter next esc
bestätigen
enter esc
Speicher löschen
Bitte warten
-- 00:00
1.Januar 1998
3 - 51