AGFEO basic-line plus AS 140 Operation And Program Manual page 162

3
Programming
Acknowledge tone or error tone - If an
input is invalid, you hear the error tone
immediately. Replace the handset and start
the entry again from the beginning.
You will hear the acknowledge tone if all
inputs have been clearly terminated after a
programming code number and are valid.
The message "done" appears in the system
telephone display.
Exiting the programming mode ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
After you have made all the settings, you
exit the programming mode.
h PS700
Lift handset Exit the programming mode
Reinstating the as-delivered state ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
In the case of an unclear programming, you
can reinstate the as-delivered state (delete
memory).
The programming mode must be started with S705 !
h PS709
Lift handset Reinstate as-delivered state
Continue programming or exit programming mode with S700 !
3 - 4
If the length of an entry is variable, e.g. the
length of an external phone number or
number of users of a call distribution, you
will not hear any tone. As a check you can
terminate the entry with the
then hear the acknowledge tone.
At the same time you save the new settings.
These are retained even in the event of a
power failure.
Q Pª
Acknowledge tone Replace handset
Delete memory - Attention! All existing
connections are cleared. All data are
deleted.
Waiting time approx. 2 minutes!
Q Pª
Acknowledge tone Replace handset
r
key and will