AGFEO basic-line plus AS 140 Operation And Program Manual page 171

Entering the connection type: Enter connection type* ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
!91
Note the display: If the setup code is re-
quested after pressing 9, you must enter the
code in 4 digits.
Display: No external phone number defined
Display: An external phone number is already
defined at position P00.
$
With "enter" to selection of the connection
type
$
With "enter" to the display
– PTMP (point-to-multipoint connection)
&
With "next" possibly select connection type
– PTP (point-to-point connection)
&
With "next"
– PTP-DDI (special direct dialing in the point-
to-point connection)
$
Confirm selection of the connection type
with "enter".
"next": select next position
or
after "enter" with "next": to enter
connection type, external phone number, call
variants
or
"set": exit programming
S
* Use -procedure on the ST 25 of AS 141, AS 191
3
Programming
P00 no entry
enter next esc
ext. 987654321
enter next esc
connection type
enter
ext. 987654321
PTMP next
ext. 987654321
PTP next
ext. 987654321
PTP-DDI next
ext. 987654321
enter next esc
3 - 13