Radyne DMD15 Installation And Operation Manual page 141

User Interfaces
<1> Common Alarm 1
<1> Common Alarm 2
Opcode: <2A00h> Command a demodulator's configuration
<1> Mode
<4> Frequency
<2> Sweep Delay
<4> Data Rate
<1> Sweep Boundary
<1> Input Level Limit
<2> Strap Code
<1> Filter Mask
<1> Demodulation Type
<1> Convolutional
Decoder
<1>
Reed Solomon
<1>
Differential Decoder
<1>
Descrambler Control
4-90
Bit 4 = E1 FAS alarm received. 1 = Received
Bit 5 = E1 MFAS alarm received. Not valid in FAS mode. 1 =
Received
Bit 6 = E1 CRC alarm received. 1 = Received
Bit 7 = CRC calculation error. 1 = Fail
Bit 0 = -12V alarm. 1 = Fail
Bit 1 = +12V alarm. 1 = Fail
Bit 2 = +5V alarm. 1 = Fail
Bit 3 = Reserved
Bit 4 = Battery. 1 = Fail
Bit 5 = RAM and ROM alarm flag. 1 = Fail
Bits 6 and 7 = Spares
Bit 0 = M&C processor fault. 1 = Fail
Bit 1 = U IO card present. 1 = Present, reserved in RCS10/10L
mode
Bit 2 = IF card present. 1 = Present
Bits 3 - 7 = Spares
0 = Closed Net. 1 = IDR, 2 = IBS, 3 = D&I
Selects the IF frequency in Hz. The range is 50 MHz to 180
MHz for the 70/140 MHz type modems and 950 MHz to 1750
MHz for the L-Band Modems.
Unsigned 0.0 – 900.0
Binary value, 0.1 second steps 0.1 – 299.9
Binary value, 1 bps steps
Sweep limits. Max of ± 32 kHz in kHz steps 1 - 32
Lower level limit, binary value, 1 dB steps. Reserved
Binary value
0 = INTELSAT, 1 = EUTELSAT, 2 = CLOSED NET1
0 = QPSK, 1 = BPSK, 2 = 8PSK, 3 = 16QAM, 4 = OQPSK
0 = None, 1 = Viterbi 1/2 Rate, 2 = Viterbi 2/3 Rate, 3 = Viterbi
3/4 Rate, 4 = Viterbi 5/6 Rate, 5 = Viterbi 7/8 Rate, 6 = Viterbi
8/9 Rate, 7 = Sequential 1/2 Rate, 8 = Sequential 2/3 Rate, 9 =
Sequential 3/4 Rate, 10 = Sequential 5/6 Rate, 11 = Sequential
7/8 Rate, 12 = Sequential 8/9 Rate, 13 = Trellis 1/2 Rate, 14 =
Trellis 2/3 Rate, 15 = Trellis 3/4 Rate, 16 = Trellis 5/6 Rate, 17
= Trellis 7/8 Rate, 18 = Trellis 8/9 Rate, 19 = SEQ 3/4 Rate,
20 = TPC .793 2D, 21 = TPC .495 3D, 22 = TPC .325 3D
0 = Disable, 1 = Enable
0 = Off, 1 = On, 2 = EF Mode*
*Available in uncoded QPSK modulation for compatibility.
0 = Disable, 1 = Enable
DMD15/DMD15L IBS/IDR Satellite Modem
TM051 – Rev. 5.8