Radyne DMD15 Installation And Operation Manual page 116

DMD15/DMD15L IBS/IDR Satellite Modem
<1> Online Flag
<1> +5V Voltage
<1> +12V Voltage
<1> -12V Voltage
<2> Temperature
<1> ESC Source
<1> Alarm 3
AUPC Remote Test
<2>
2047 BER Mantessa
AUPC Remote Test
<1>
2047 BER Exponent
Reserved
<1>
Symbol Rate
<4>
Latched Alarm 2
<17>
Reserved
<2>
Latched Drop Status
<17>
<4>
Reserved
TM051 - Rev. 5.8
Bit 1 = Multiframe lock Fault. Valid in E1 PCM30 and PCM30C.
1 = Fail
Bit 2 = CRC lock fault. Valid in T1ESF, and E1 CRC enabled. 1
= Fail
Bit 3 = T1 yellow alarm received. 1 = Received
Bit 4 = E1 FAS alarm received. 1 = Received
Bit 5 = E1 MFAS alarm received. Not valid in FAS mode. 1 =
Received
Bit 6 = E1 CRC alarm received. 1 = Received
Bit 7 = CRC calculation error. 1 = Fail
0 = Offline, 1 = Online
+5V. Implied decimal point. ex: 49 = +4.9 V
+12V. Implied decimal point. ex: 121 = +12.1 V
-12V. Implied decimal point and minus sign. ex: 118 = -11.8 V
Degrees C. Implied decimal point. ex: 490 = 49.0 C
(Not Implemented)
0 = Internal, 1 = External
Bit 0 = Backward Alarm 1 Transmitted
Bit 1 = Backward Alarm 2 Transmitted
Bit 2 = Backward Alarm 3 Transmitted
Bit 3 = Backward Alarm 4 Transmitted
Bits 4 - 7 = Spare
0 = No, 1 = Yes
Binary value with implied decimal point; 795 = 7.95)
Binary value with implied sign; 6 = -6
Ignore
Binary value, 1 sps steps
Bit 0 = Terrestrial Clock. Activity Detect. 1 = Fail
Bit 1 = Internal Clock. Activity Detect. 1 = Fail
Bit 2 = Tx Sat Clock. Activity Detect. 1 = Fail
Bit 3 = Tx Data Activity Detect. 1=Fail
Bit 4 = Tx Data AIS Detect. 1=Fail
Bit 5 = Tx Clock Fall Back. 1=Fail
Bits 6 and 7 = Spares
Reserved
Bit 0 = Framelock Fault. 1=Fail
Bit 1 = Multiframe Lock Fault. Valid in E1 PCM30 & PCM03. 1 = Fail
Bit 2 = CRC Lock Fault. Valid in T1 ESF, & E1 CRC Enabled. 1 = Fail
Bit 3-7 (Not Latched)
Reserved
User Interfaces
4-65