Radyne DMD15 Installation And Operation Manual page 123

User Interfaces
<1>
Tx ESC Ch 2 Volume
<1>
Tx Interface Type
<1>
Tx Terrestrial
Loopback
<1>
Tx Baseband
Loopback
<1>
Drop Status Mask
<1>
Tx RS N Code
<1>
Tx RS K Code
<1>
Tx RS Depth
<1>
Data Invert
<1>
BPSK Symbol Pairing
<1>
IDR Overhead Type
<1>
Terminal Emulation
<1>
Terminal Baud Rate
<1>
FM Orderwire Mode
<1>
FM Orderwire Test
Tone
<1>
AUPC Local Enable
<1>
AUPC Remote Enable
<1>
AUPC Local CL
Action
<1>
AUPC Remote CL
Action
<1>
AUPC Tracking Rate
4-72
-20 to +10 (+10 dBm to –20 dBm) (two's compliment)
0 = G703-B-T1-AMI, 1 = G703-B-T1_B8ZS, 2 = G703-B-E1, 3
= G703-B-T2, 4 = G703-U-E1, 5 = G703-U-T2, 6 = G703-U-E2,
7 = RS-422, 8 = V.35, 9 = RS-232
0 = Disabled, 1 = Enabled
0 = Disabled, 1 = Enabled
Bit 0 = Frame lock mask
Bit 1 = Multiframe lock mask. Valid in E1 PCM30 and PCM30C
Bit 2 = CRC lock mask. Valid in T1ESF, and E1 CRC enabled
Bit 3 = T1 yellow alarm received mask
Bit 4 = E1 FAS alarm received mask
Bit 5 = E1 MFAS alarm received mask. Not valid in FAS mode
Bit 6 = E1 CRC alarm received mask
Bit 7 = CRC calculation error
0 = Mask, 1 = Allow
2 - 255. Reed-Solomon code word length
1 - 254. Reed-Solomon message length
4 or 8
0 = None, 1 = Terrestrial, 2 = Baseband, 3 = Terrestrial and
Baseband
0 = Normal Pairing, 1 = Swapped Pairing
0 = 32K Voice. 1 = 64K Data
0 = Adds Viewpoint. 1 = VT100, 2 = WYSE50
0 = 300, 1 = 600, 2 = 1200, 3 = 2400, 4 = 4800, 5 = 9600, 6 =
19200, 7 = 38400, 8 = 150
0 = Disable, 1 = Enable, 2 = FM Only
0 = Off, 1 = On
0 = Off, 1 = On
0 = Off, 1 = On
0 = Hold, 1 = Nominal, 2 = Maximum
0 = Hold, 1 = Nominal, 2 = Maximum
0 = 0.5 dB/Min, 1 = 1.0 dB/Min, 2 = 1.5 dB/Min, 3 = 2.0 dB/Min,
DMD15/DMD15L IBS/IDR Satellite Modem
TM051 – Rev. 5.8