Headlamp Flasher - Mitsubishi L200 Owner's Manual

l If the lamps do not turn on or off with the
switch in the "AUTO" position, manually op-
erate the switch and we recommend you to
have your vehicle checked.
[Vehicles with Daytime Running Lamp]
When the ignition switch is in the "ON" position
and the lamp switch is set to the "OFF" position,
the low beam of the headlamps, tail lamps, etc.,
will illuminate.
Lamps (headlamps, fog lamp, etc.) au-
to-cutout function
l If the ignition key is turned to "LOCK" or
"ACC" position or removed from the igni-
tion switch and the lamps will stay on for
about 3 minutes without opening the driver's
door while the lamp switch in the "
tion, the lamps automatically turn off.
l If the ignition key is turned to "LOCK" or
"ACC" position or removed from the igni-
tion switch and the driver's door is opened
within 3 minutes while the lamp switch in
the " " position, a buzzer will sound to
warn the driver that the lamps have not been
turned off, and these lamps will automatical-
ly turn off.
NOTE
l The lamp auto-cutout will not function when
the lamp switch is in the "
l When the ignition key has been turned either
to the "LOCK" or "ACC" position or re-
moved from the ignition switch with the
lamp switch in the " " position, and the
lamp switch is returned to the "OFF" posi-
tion within approximately 3 minutes, the auto-
cutout function will not be activated.
When you want to keep the lamps on
l Turn the switch in the "OFF" position to
switch off all lamps while the ignition key is
in the "LOCK" or "ACC" position or re-
move it from the ignition switch.
l
Turn on the lamps with the switch in the
" " or " " position again, then the
lamps will remain on.
" posi-
NOTE
l It is possible to alter the auto-cutout function
such that:
• Auto-cutout function is never activated.
For details, we recommend you to consult a
MITSUBISHI MOTORS Authorized Service
Point.
OCRE12E1
Lamp monitor buzzer
If the driver's door is opened when the ignition key
is in the "LOCK" or "ACC" position or removed
from the ignition switch while the lamps are on, a
buzzer will sound to remind the driver to turn off
the lamps. When the lamp auto-cutout function
acts, the buzzer will stop automatically. When this
function does not act, turn off the lamp switch to
stop the buzzer.
Dipper (High/Low beam change)
" position.
When the lamp switch is in the "
beam changes from high to low (or low to high)
each time the lever is pulled to (1). While the high-
beam is on, the high-beam indication lamp in the in-
strument cluster will also illuminate.

Headlamp flasher

The high-beams flash when the lever is pulled slight-
ly (2), and will go off when it is released.
When the high-beam is on, the high-beam indica-
tion lamp in the instrument cluster will also illumi-
nate.
Instruments and controls
E00506100184
E00506200286
" position, the
3
E00506300157
3-31