Steering Wheel Lock - Mitsubishi L200 Owner's Manual

Starting and driving
NOTE
l
If your vehicle is equipped with the Daytime
Running Lamp, when the ignition switch is
in the "ON", the headlamp low beams etc.
are turned on.
Refer to "Headlamps" on page 3-30.
l Your vehicle is equipped with an electronic
immobilizer.
To start the engine, the ID code which the
transponder inside the key sends must match
the one registered in the immobilizer comput-
er.
Refer to "Electronic immobilizer" on page
1-03.
To remove the key
Push the key in at the "ACC" position and keep it
depressed until it is turned to the "LOCK" position
4 and remove it.
4-12
CAUTION
l
Do not remove the ignition key from the
ignition switch while driving. The steer-
ing wheel will be locked, causing loss of
control.
l If the engine is stopped while driving, the
brake servomechanism will cease to func-
tion and braking efficiency will deterio-
rate. Also, the power steering system will
not function and it will require greater
manual effort to operate the steering.
l Do not leave the key in the "ON" position
for a long time when the engine is not run-
ning, doing so will cause the battery to be
discharged.
l Do not turn the key to the "START" posi-
tion when the engine is running, doing so
could damage the starter motor.
OCRE12E1

Steering wheel lock

E00601500227
To lock
Remove the key at the "LOCK" position.
Turn the steering wheel until it is locked.
To unlock
Turn the key to the "ACC" position while moving
the steering wheel slightly.
CAUTION
l Remove the key when leaving the vehicle.
NOTE
l If the front wheels are turned, the anti-theft
lock may sometimes make it difficult to turn
the key from "LOCK" to "ACC". Firmly
turn the steering wheel to the left or to the
right as you turn the key.