Headlamp Flasher - Mitsubishi ASX Manual

Dipper (High/Low beam change)
E00506200329
When the lamp switch is in the " " position, the
beam changes from high to low (or low to high)
each time the lever is pulled fully (1). While the high-
beam is on, the high-beam indication lamp in the in-
strument cluster will also illuminate.

Headlamp flasher

E00506300199
The high-beams flash when the lever is pulled slight-
ly (2), and will go off when it is released.
When the high-beam is on, the high-beam indica-
tion lamp in the instrument cluster will illuminate.
NOTE
l The high-beams can also flash when the
lamp switch is OFF.
l If you turn the lamps off with the headlamps
set to high-beam, the headlamps are automat-
ically returned to their low-beam setting
when the lamp switch is next turned to the
" " position.
Welcome light*
E00528900254
This function turns on the position and tail lamps
for about 30 seconds after the UNLOCK switch
(A) on the remote control transmitter is pressed
when the combination headlamps and dipper
switch is in the "OFF" or "AUTO" position (for ve-
hicles equipped with the automatic lamp control).
On vehicles equipped with automatic lamp control,
the welcome light function will operate only when
it is dark outside the vehicle.
NOTE
l
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch (B) on the remote
control transmitter.
Instruments and controls
• Turn the combination headlamps and dip-
per switch to the " " or " " position.
• Turn the ignition switch to the "ON" po-
sition or put the operation mode in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting instead of the posi-
tion and tail lamps.
• The welcome light function can be deacti-
vated.
For further information, please contact
your MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make
the adjustment. Refer to the separate own-
er's manual for details.
Coming home light
E00529000236
This function turns on the headlamps in the low
beam setting for about 30 seconds after the ignition
switch is turned to the "OFF" position or the opera-
tion mode is put in OFF.
3
3-47