Starting and driving
Cruise control*
Cruise control is an automatic speed control system
that keeps a set speed. It can be activated at about
40 km/h (25 mph) or more.
CAUTION
l
When you do not wish to drive at a set
speed, turn off the cruise control for safety.
l
Do not use cruise control when driving
conditions will not allow you to stay at
the same speed, such as in heavy traffic
or on roads that are winding, icy, snow-
covered, wet, slippery, on a steep down-
hill slope.
l
On vehicles with manual transmission, do
not move the gearshift lever to the "N"
4
(Neutral) position while driving at a set
speed without depressing the clutch ped-
al. The engine will run too fast and might
be damaged.
NOTE
l
Cruise control may not be able to keep your
speed on uphills or downhills.
l
Your speed may decrease on a steep uphill.
You may use the accelerator pedal if you
want to stay at your set speed.
l
Your speed may increase to more than the
set speed on a steep downhill. You must use
the brake to control your speed. As a result,
the set speed driving is deactivated.
4-50
Cruise control switches
E00609100779
A- "ON OFF" switch
Used to turn on and off the cruise control.
B- "COAST SET" switch
Used to reduce the set speed and to set the desired
speed.
C- "ACC RES" switch
Used to increase the set speed and to return to the
original set speed.
D- "CANCEL" switch
Used to deactivate the set speed driving.
NOTE
l
When operating the cruise control switches,
press the cruise control switches correctly.
The set speed driving may be deactivated au-
tomatically if two or more switches of the
cruise control are pressed at the same time.
OCRE12E1
To activate
E00624100103
1. With the ignition switch in the "ON" posi-
tion, press the "ON OFF" switch (A) to turn
on the cruise control. The "CRUISE" indica-
tion lamp in the meter cluster will come on.
NOTE
l
If the cruise control is on when the ignition
switch is turned to the "LOCK" or "ACC" po-
sition, cruise control will be on automatically
the next time you start the engine.
The "CRUISE" indication lamp will also be
on.
l
If the battery voltage is insufficient, the mem-
ory data for the cruise control may be erased.
As a result, the "CRUISE" indication lamp
may not come on when you restart the engine.
If this happens, press the "ON OFF" switch
once again to turn on the cruise control.
E00609300771