Super Select 4Wd - Mitsubishi L200 Owner's Manual

Starting and driving
"4H" ↔ "4L"
Transfer shift lever posi- 2WD/4WD operation
tion indication lamp
4H
4
Drive mode switching
in progress
4L
: Illuminate
: Remain off
4-30
NOTE
l
The 2WD/4WD operation indication lamp
will go out momentarily during shifting proc-
ess from "4H" to "4L" or vice versa, as the
transfer shift lever passes through the neutral
position.
Be sure to operate the transfer shift lever un-
til the 2WD/4WD operation indication lamp
illuminates again.
l If, after a "4H" ↔ "4L" selection has been
made, the 2WD/4WD operation indication
lamp remains off and the desired range is not
actually selected, return the transfer shift lev-
er to its previous position. Place the steering
wheel in the straight ahead position, drive
the vehicle forward, and release the accelera-
tor pedal. Next, hold down the clutch pedal
(with manual transmission) or place the selec-
tor lever in the "N" (NEUTRAL) position
(with automatic transmission) and make the
range selection again.
OCRE12E1

Super select 4WD*

E00605700197
Shifting to rear-wheel drive or 4-wheel drive can
be made by operating the transfer shift lever (A).
Shift the transfer shift lever to an appropriate posi-
tion according to the road surface conditions. In ad-
dition, the 2WD/4WD operation indication lamp in-
dicates the transfer shift lever shifting state. Refer
to "2WD/4WD operation indication lamp" on page
4-33.
Vehicles with manual transmission
Vehicles with automatic transmission