Mitsubishi L200 Owner's Manual page 157

Starting and driving
To shift from To
2H 4H
4H 2H or 4HLc
4HLc 4H
4HLc 4LLc
4LLc 4HLc
4
NOTE
l Shifting of the transfer shift lever between
"2H" ↔ "4H" should only be done at speeds
below 100 km/h (62 mph).
l During driving, never attempt to shift from
"4HLc" to "4LLc".
l When shifting from "2H" to "4H" in cold
weather while the vehicle is in motion, the
transmission gear may make some noise. In
cold weather, try to shift the gear while the
vehicle is stopped.
4-32
Vehicles with manual transmission
The transfer shift lever can be operated while the vehicle is
either moving or stationary.
When the vehicle is not in motion, shift the gearshift lever
to the "N" (Neutral) position before operating the transfer
shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, and release the accelerator pedal be-
fore operating the transfer shift lever.
Stop the vehicle, depress the clutch pedal to the floor and
operate the transfer shift lever while keeping the transfer
shift lever pushed down.
Keep depressing the clutch pedal while the 2WD/4WD op-
eration indication lamp continues to blink.
l
When the transfer shift lever is shifted from
"4H" to "4HLc" while the vehicle is stopped,
the 2WD/4WD operation indication lamp
blinks while the selection is in process. Drive
slowly and normally after confirming that
the lamp is illuminated. (Refer to "2WD/
4WD operation indication lamp" on page
4-33.)
l Do not move the selector lever while the 2WD/
4WD operation indication lamp is blinking.
l The 2WD/4WD operation indication lamp
will go out momentarily during shifting proc-
ess from "4HLc" to "4LLc" or vice versa, as
the transfer shift lever passes through the neu-
tral position.
Be sure to operate the transfer shift lever un-
til the 2WD/4WD operation indication lamp
illuminates again.
OCRE12E1
Procedure
Vehicles with automatic transmission
The transfer shift lever can be operated while the vehicle
is either moving or stationary.
When the vehicle is not in motion, shift the selector lever
to the "N" (NEUTRAL) position before operating the
transfer shift lever.
When the vehicle is moving, and only while it can be
steered straight ahead, shift the selector lever to the "D"
(DRIVE) position, and release the accelerator pedal be-
fore operating the transfer shift lever.
Stop the vehicle, shift the selector lever to the "N" (NEU-
TRAL) position, and operate the transfer shift lever
while keeping the transfer shift lever pushed down.
If operation is made with the selector lever placed in any
other position than "N" (NEUTRAL) position, a gear
noise may be generated, with a possible failure to shift in-
to a proper gear.
l
There may be a case that the transfer shift lev-
er feels heavy when it is moved from "2H"
to "4H" with the steering wheel in turned po-
sition.
This is normal and not any indication of trou-
ble.
CAUTION
l Do not operate the transfer shift lever
while the rear wheels of the vehicle are
slipping on snow or ice.