Mitsubishi L200 Owner's Manual page 159

Starting and driving
"4HLc" ↔ "4LLc"
Transfer shift lever posi- 2WD/4WD operation
tion indication lamp
4HLc
Drive mode switching
in progress
4
4LLc
: Blink
: Illuminate
: Remain off
NOTE
l The 2WD/4WD operation indication lamp
blinks while the selection is in process. Take
4-34
the following precautions when the indica-
tion lamp is blinking or remains off.
• Keep the steering wheel in the straight
ahead position while making range selec-
tions. If you attempt to drive forward
with the steering wheel turned, gear rat-
tling may occur and the desired range
may not actually be selected.
• If you move the transfer shift lever from
"4H" to "4HLc" while the vehicle is sta-
tionary, keep your speed initially very
low when you subsequently make a stand-
ing start. Before driving at normal
speeds, confirm that the centre differen-
tial lock lamp has changed from blinking
to steady illumination.
• If you move the transfer shift lever from
"4HLc" to "4H" and the centre differen-
tial lock lamp does not stop blinking,
place the steering wheel in the straight
ahead position and slowly depress the ac-
celerator pedal several times.
• If you move the transfer shift lever from
"4H" to "2H" and the front wheel lamp
does not stop blinking, confirm safety
around the vehicle then accelerate, decel-
erate, and reverse until the front wheel
lamp goes off. When the front wheel
lamp goes off, you can then proceed to
drive the vehicle.
If you accelerate, decelerate, and reverse
but the front wheel lamp still does not
stop blinking, return the transfer shift lev-
er to "4H" then have your vehicle inspec-
ted.
OCRE12E1
l When you move the transfer shift lever from
"4H" to "4HLc", there may be a slight delay
before the centre differential lock lamp illu-
minates.