Headlamp Flasher - Mitsubishi Outlander 2015 Owner's Manual

Combination headlamps and dipper switch
NOTE
l
If the lamp switch is in the "
position, or if the tail lamps are on when the
lamp switch is in the "AUTO" position, the
daytime running lamps come on as position
lamps.
5
Dipper (High/Low beam
change)
When the lamp switch is in the "
tion, the beam changes from high to low (or
low to high) each time the lever is pulled
fully (1). While the high-beam is on, the
high-beam indication lamp in the instrument
cluster will also illuminate.
5-58 Instruments and controls

Headlamp flasher

" or " "
The high-beams flash when the lever is
pulled slightly (2), and will go off when it is
released.
When the high-beam is on, the high-beam in-
dication lamp in the instrument cluster will il-
luminate.
NOTE
E00506200329
" posi-
l The high-beams can also flash when the
lamp switch is OFF.
l If you turn the lamps off with the headlamps
set to high-beam, the headlamps are auto-
matically returned to their low-beam setting
when the lamp switch is next turned to the
" " position.
Welcome light
This function turns on the position and tail
lamps for about 30 seconds after the UN-
LOCK switch on the remote control transmit-
ter is pressed when the combination head-
lamps and dipper switch is in the "OFF" or
"AUTO" position (for vehicles equipped with
the automatic lamp control). On vehicles
equipped with the automatic lamp control
(except for vehicles equipped with LDW),
the welcome light function will operate only
when it is dark outside the vehicle.
OGFE16E1
NOTE
E00506300199
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch on the remote
control transmitter.
• Turn the combination headlamps and dip-
per switch to the "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with MITSUBISHI
Multi-Communication
screen operations can be used to make the
adjustment. Refer to the separate owner's
E00528900560
manual for details.
Coming home light
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the ignition switch is turned to the "LOCK"
position or the operation mode is put in OFF.
1. Turn the combination headlamps and
dipper switch to the "OFF" or "AUTO"
position (for vehicles equipped with the
automatic lamp control).
" or " " position.
System (MMCS),
E00529001624