Configuring A Username And Password For A Vam Client; Configuring An Advpn Tunnel Interface - HP FlexNetwork MSR2003 Configuration Manual

Step
2. Enter VAM client view.
3. Set the dumb timer.

Configuring a username and password for a VAM client

The VAM client uses the configured username and password for authentication on the server.
To configure a username and password for a VAM client:
Step
1. Enter system view.
2. Enter VAM client view.
3. Configure a username and
password for the client.

Configuring an ADVPN tunnel interface

ADVPN establishes tunnels over ADVPN tunnel interfaces.
To configure an ADVPN tunnel interface:
Step
1. Enter system view.
2. Create an ADVPN tunnel
interface and enter its view.
3. Configure a private IPv4 or
IPv6 address for the tunnel
interface.
Command
vam client name client-name
dumb-time time-interval
Command
system-view
vam client name client-name
user username password
{ cipher cipher-string | simple
simple-string }
Command
system-view
interface tunnel number [ mode
advpn { gre | udp } [ ipv6 ] ]
•
Configure a private IPv4
address:
ip address ip-address
{ mask | mask-length } [ sub ]
•
Configure a private IPv6
address:
ipv6 address ipv6-address
prefix-length
345
Remarks
N/A
By default, the dumb timer is 120
seconds.
Remarks
N/A
N/A
By default, no username and
password is configured for the
client.
Remarks
N/A
By default, no tunnel interface is
created.
The two ends of an ADVPN tunnel
must use the same tunnel mode.
By default, no private address is
configured for the tunnel interface.
All tunnel interfaces in a hub
group must reside in the same
private network.