HP FlexNetwork MSR2003 Configuration Manual page 177

[Router-GigabitEthernet2/0/2] quit
# Enable static NAT on interface GigabitEthernet 2/0/1.
[Router] interface gigabitethernet 2/0/1
[Router-GigabitEthernet2/0/1] nat static enable
[Router-GigabitEthernet2/0/1] quit
Verifying the configuration
# Verify that Host A and Host B can access each other. The public address for Host A is 172.16.1.2
and that for Host B is 172.16.2.2. (Details not shown.)
# Display all NAT configuration and statistics.
[Router] display nat all
Static NAT mappings:
Totally 2 outbound static NAT mappings.
IP-to-IP:
Local IP
Global IP
Local VPN
Global VPN
Config status: Active
Global flow-table status: Active
Local flow-table status: Active
IP-to-IP:
Local IP
Global IP
Local VPN
Global VPN
Config status: Active
Global flow-table status: Active
Local flow-table status: Active
Interfaces enabled with static NAT:
Totally 2 interfaces enabled with static NAT.
Interface: GigabitEthernet2/0/1
Config status: Active
Interface: GigabitEthernet2/0/2
Config status: Active
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
: 192.168.1.2
: 172.16.1.2
: vpn1
: vpn2
: 192.168.1.2
: 172.16.2.2
: vpn2
: vpn1
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
163