HP FlexNetwork MSR2003 Configuration Manual page 440

Figure 154 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure routing protocols to ensure connectivity.
3. Configure WAAS classes:
# Create WAAS class c1 on Router A, and configure the WAAS class to match any TCP
packets.
<RouterA> system-view
[RouterA] waas class c1
[RouterA-waasclass-c1] match 1 tcp any
[RouterA-waasclass-c1] quit
# Create WAAS class c1 on Router B, and configure the WAAS class to match any TCP
packets.
<RouterB> system-view
[RouterB] waas class c1
[RouterB-waasclass-c1] match tcp any
[RouterB-waasclass-c1] quit
4. Configure WAAS policies:
# Create WAAS policy p1 on Router A, use WAAS class c1, and configure TFO, DRE, and LZ
optimization actions in the WAAS class.
[RouterA] waas policy p1
[RouterA-waaspolicy-p1] class c1
[RouterA-waaspolicy-p1-c1] optimize tfo dre lz
[RouterA-waaspolicy-p1-c1] quit
[RouterA-waaspolicy-p1] quit
# Create WAAS policy p1 on Router B, use WAAS class c1, and configure TFO, DRE, and LZ
optimization actions in the WAAS class.
[RouterB] waas policy p1
[RouterB-waaspolicy-p1] class c1
[RouterB-waaspolicy-p1-c1] optimize tfo dre lz
[RouterB-waaspolicy-p1-c1] quit
[RouterB-waaspolicy-p1] quit
5. Apply WAAS policies:
# Apply WAAS policy p1 to interface GigabitEthernet 2/0/1 on Router A.
426