Ssh Client Configuration Examples; When Switch Acts As Client For Password Authentication - HP 5120 SI Series Security Configuration Manual

Figure 88 SSH client configuration interface 2)
In the window shown in
will be prompted to enter the username. After entering the username client002, you can enter the
configuration interface of the server.

SSH client configuration examples

Unless otherwise noted, devices in the configuration examples are operating in non-FIPS mode.

When switch acts as client for password authentication

Network requirements
As shown in
B (the SSH server) through the SSH protocol. Configure the username client001 and the password aabbcc
for the SSH client on Switch B.
Figure 89 Switch acts as client for password authentication
SSH server
Vlan-int1
10.165.87.136/24
Switch B
Configuration procedure
1. Configure the SSH server
Figure 93, click Open to connect to the server. If the connection is normal, you
Figure 94, Switch A (the SSH client) must pass password authentication to log in to Switch
Vlan-int1
10.165.87.137/24
SSH client
Switch A
260