Configuring A Waas Policy; Applying A Waas Policy To An Interface - HP FlexNetwork MSR2003 Configuration Manual

Step
3. Configure a match criterion.

Configuring a WAAS policy

To configure a WAAS policy, perform the following tasks:
1. Create a WAAS policy.
2. Use a WAAS class in the WAAS policy.
3. Configure actions for the WAAS class.
4. Enable optimization features.
You can configure the following actions for a WAAS class:
•
Optimization actions—Optimize matching TCP traffic and include TFO, DRE, and LZ
compression. TFO is required. DRE and LZ compression are optional.
•
Passthrough action—Allows matching TCP traffic to pass through unoptimized.
To configure a WAAS policy:
Step
1. Enter system view.
2. Create a WAAS policy and
enter WAAS policy view.
3. Specify a WAAS class and
enter WAAS policy class
view.
4. Configure optimization
actions or the passthrough
action.
5. Return to system view.
6. Enable DRE.
7. Enable LZ compression.

Applying a WAAS policy to an interface

Apply a WAAS policy to the interface that connects to the WAN. The device optimizes or passes
through the traffic entering and leaving the WAN according to the configured policy. If traffic enters
and leaves the device on interfaces that are both connected to the WAN, the traffic is not optimized.
A WAAS policy can be applied to multiple interfaces. Only one WAAS policy can be applied to an
interface.
Command
match [ match-id ] tcp { any |
destination | source }
[ ip-address ip-address
[ mask-length | mask ] |
ipv6-address ipv6-address
[ prefix-length ] ] [ port port-list ]
Command
system-view
waas policy policy-name
class class-name
[ insert-before existing_class ]
•
optimize tfo [ dre | lz ] *
•
passthrough
quit
waas tfo optimize dre
waas tfo optimize lz
420
Remarks
By default, no match criterion is
configured.
Remarks
N/A
By default, only the predefined
WAAS policy exists.
As a best practice, configure a
WAAS policy by modifying the
predefined WAAS policy.
By default, no WAAS class is
specified.
By default, no action is configured.
An optimization action takes effect
only when the corresponding feature
is enabled.
N/A
By default, DRE is enabled.
By default, LZ compression is
enabled.