Ipv4 Full-Mesh Nat Traversal Advpn Configuration Example - HP FlexNetwork MSR2003 Configuration Manual

192:168:1::2
The output shows that Spoke 1 has established a permanent hub-spoke tunnel to Hub 1 and Hub 2.
# Display IPv6 ADVPN tunnel information on Spoke 3 and Spoke 4. This example uses Spoke 4.
[Spoke3] display advpn ipv6 session
Interface
Number of sessions: 1
Private address
192:168:2::1
The output shows that Spoke 3 has established a permanent hub-spoke tunnel to Hub 3.

IPv4 full-mesh NAT traversal ADVPN configuration example

Network requirements
As shown in
primary and secondary VAM servers manage and maintain VAM client information for all hubs and
spokes. The AAA server performs authentication and accounting for VAM clients. The two hubs back
up each other, and perform data forwarding and route exchange.
•
Establish a permanent ADVPN tunnel between each spoke and each hub.
•
Establish a temporary ADVPN tunnel dynamically between the two spokes in the same ADVPN
domain.
Figure 152 Network diagram
1::2
: Tunnel1
Public address
1::3
Figure 152, all the VAM servers and VAM clients reside behind a NAT gateway. The
18001 S-H Success
Port Type State
18001 S-H Success
408
0H 46M 8S
Holding time
0H 46M 8S