HP FlexNetwork MSR2003 Configuration Manual page 169

Totally 1 NAT inbound rules.
Interface: GigabitEthernet2/0/2
ACL: 2000
NO-PAT: N
Config status: Active
Global flow-table status: Active
NAT outbound information:
Totally 1 NAT outbound rules.
Interface: GigabitEthernet2/0/2
ACL: 2000
NO-PAT: Y
Config status: Active
Global flow-table status: Active
NAT internal server information:
Totally 1 internal servers.
Interface: GigabitEthernet2/0/2
Protocol: 17(UDP)
Global IP/port: 202.38.1.4/53
Local IP/port : 200.1.1.3/53
Config status : Active
Global flow-table status: Active
Local flow-table status: Active
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL : ---
Config status: Active
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled
PPTP : Enabled
Address group: 2
Reversible: N
Address group: 1
Reversible: Y
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
155
Add route: N
Port-preserved: N