Enabling Ipv4 Local Fragment Reassembly; Displaying And Maintaining Ip Performance Optimization - HP FlexNetwork MSR2003 Configuration Manual

Flexnetwork msr router series
Hide thumbs Also See for FlexNetwork MSR2003:
Table of Contents

Advertisement

Step
2.
Specify the source
address for outgoing
ICMP packets.

Enabling IPv4 local fragment reassembly

Perform this task to enable the local reassembly feature for IPv4 fragments that are destined for the
local device. This feature enables the receiving LPU to reassemble the IPv4 fragments instead of
delivering them to the active MPU for reassembly. It improves the fragment reassembly
performance.
To enable IPv4 local fragment reassembly:
Step
1.
Enter system view.
2.
Enable IPv4 local
fragment reassembly.
Displaying and maintaining IP performance
optimization
Execute display commands in any view and reset commands in user view.
Task
Display brief information about RawIP connections
(centralized devices in standalone mode).
Display brief information about RawIP connections
(distributed devices in standalone mode/centralized devices in
IRF mode).
Display brief information about RawIP connections
(distributed devices in IRF mode).
Display detailed information about RawIP connections
(centralized devices in standalone mode).
Display detailed information about RawIP connections
(distributed devices in standalone mode/centralized devices in
IRF mode).
Display detailed information about RawIP connections
(distributed devices in IRF mode).
Display brief information about TCP connections (centralized
devices in standalone mode).
Display brief information about TCP connections (distributed
devices in standalone mode/centralized devices in IRF mode).
Command
ip icmp source
[ vpn-instance
vpn-instance-name ]
ip-address
Command
system-view
ip reassemble local enable
193
Remarks
By default, the device uses the IP
address of the sending interface as the
source IP address for outgoing ICMP
packets.
Remarks
N/A
By default, IPv4 local fragment
reassembly is disabled.
This feature applies only to fragments
received by the same LPU.
Command
display rawip
display rawip [ slot slot-number ]
display rawip [ chassis chassis-number
slot slot-number ]
display rawip verbose [ pcb pcb-index ]
display rawip verbose [ slot slot-number
[ pcb pcb-index ] ]
display rawip verbose [ chassis
chassis-number slot slot-number [ pcb
pcb-index ] ]
display tcp
display tcp [ slot slot-number ]

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents