Configuring Ipv6 Prefix Acquisition; Configuring Ipv6 Address And Prefix Acquisition; Configuring Stateless Dhcpv6; Setting The Dscp Value For Dhcpv6 Packets Sent By The Dhcpv6 Client - HP FlexNetwork MSR2003 Configuration Manual

Configuring IPv6 prefix acquisition

Step
1. Enter system view.
2. Enter interface view.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 prefix and other
configuration parameters.

Configuring IPv6 address and prefix acquisition

Step
1. Enter system view.
2. Enter interface view.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 address, an IPv6 prefix,
and other configuration
parameters.

Configuring stateless DHCPv6

Step
1. Enter system view.
2. Enter interface view.
3. Configure the interface to
support stateless DHCPv6.
Setting the DSCP value for DHCPv6 packets sent
by the DHCPv6 client
The DSCP value of a packet specifies the priority level of the packet and affects the transmission
priority of the packet.
Command
system-view
interface interface-type
interface-number
ipv6 dhcp client pd
prefix-number [ option-group
group-number | rapid-commit ] *
Command
system-view
interface interface-type
interface-number
ipv6 dhcp client stateful prefix
prefix-number [ option-group
option-group-number |
rapid-commit ] *
Command
system-view
interface interface-type
interface-number
•
Enable stateless IPv6 address
autoconfiguration:
ipv6 address auto
•
Enable stateless DHCPv6:
ipv6 dhcp client stateless
enable
265
Remarks
N/A
N/A
By default, the interface does not
use DHCPv6 for IPv6 prefix
acquisition.
Remarks
N/A
N/A
By default, the interface does not
use DHCPv6 for IPv6 address and
prefix acquisition.
Remarks
N/A
N/A
By default, the interface does not
support stateless DHCPv6.
You can perform both tasks.
If you use only the ipv6 address
auto command, make sure the
M flag is set to 0 and the O flag is
set to 1 in the RA message.
Otherwise, stateless DHCPv6
cannot be triggered.