Displaying Proxy Arp; Common Proxy Arp Configuration Example; Network Requirements; Configuration Procedure - HP FlexNetwork MSR2003 Configuration Manual

Displaying proxy ARP

Execute display commands in any view.
Task
Display common proxy ARP
status.
Display local proxy ARP status.

Common proxy ARP configuration example

Network requirements

As shown in
different subnets. No default gateway is configured on Host A and Host D.
Configure common proxy ARP on the router to enable communication between Host A and Host D.
Figure 5 Network diagram

Configuration procedure

# Configure the IP address of interface GigabitEthernet 2/0/2.
<Router> system-view
[Router] interface gigabitethernet 2/0/2
[Router-GigabitEthernet2/0/2] ip address 192.168.10.99 255.255.255.0
# Enable common proxy ARP on interface GigabitEthernet 2/0/2.
[Router-GigabitEthernet2/0/2] proxy-arp enable
[Router-GigabitEthernet2/0/2] quit
# Configure the IP address of interface GigabitEthernet 2/0/1.
[Router] interface gigabitethernet 2/0/1
Command
display proxy-arp [ interface interface-type interface-number ]
display local-proxy-arp [ interface interface-type interface-number ]
Figure 5, Host A and Host D have the same prefix and mask, but they are located on
13