Ipv6 Multi-Hub-Group Advpn Configuration Example - HP FlexNetwork MSR2003 Configuration Manual

192.168.0.3
The output shows that Hub 1 has established a permanent tunnel to Hub 2, Hub3, Spoke 1, and
Spoke 2.
# Display IPv4 ADVPN tunnel information on Spoke 1 and Spoke 2. This example uses Spoke 1.
[Spoke1] display advpn session
Interface
Number of sessions: 2
Private address
192.168.1.1
192.168.1.2
The output shows that Spoke 1 has established a permanent hub-spoke tunnel to Hub 1 and Hub 2.
# Display IPv4 ADVPN tunnel information on Spoke 3 and Spoke 4. This example uses Spoke 3.
[Spoke3] display advpn session
Interface
Number of sessions: 1
Private address
192.168.2.1
The output shows that Spoke 3 has established a permanent hub-spoke tunnel to Hub 3.

IPv6 multi-hub-group ADVPN configuration example

Network requirements
As shown in
information for all hubs and spokes. The AAA server performs authentication and accounting for
VAM clients.
•
Configure three hub groups to accommodate all ADVPN nodes:
Hub group 0 contains Hub1, Hub2, and Hub3.
Hub group 1 contains Hub1, Hub2, Spoke1, and Spoke2. Hub 1 and Hub 2 back up each
other.
Hub group 2 contains Hub3, Spoke3, and Spoke4. Hub groups 1 and 2 use full-mesh
networking.
•
Allow any two spokes to establish a direct spoke-spoke tunnel.
1.0.0.3
: Tunnel1
Public address
1.0.0.1
1.0.0.2
: Tunnel1
Public address
1.0.0.3
Figure 151, the primary and secondary VAM servers manage and maintain VAM client
18001 H-H
Port Type
18001 S-H
18001 S-H
Port Type
18001 S-H
393
Success 0H 27M 27S
State Holding time
Success 0H 46M
Success 0H 46M
State Holding time
Success 0H 46M
8S
8S
8S