HP FlexNetwork MSR2003 Configuration Manual page 180

Totally 1 internal servers.
Interface: GigabitEthernet2/0/2
Protocol: 6(TCP)
Global IP/port: 202.38.1.1/21
Local IP/port : server group 0
Config status : Active
Global flow-table status: Active
Local flow-table status: Active
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL : ---
Config status: Active
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled
PPTP : Enabled
RSH : Enabled
RTSP : Enabled
SCCP : Enabled
SIP : Enabled
SQLNET : Enabled
TFTP : Enabled
XDMCP : Enabled
# Display NAT session information generated when external hosts access an internal FTP server.
[Router] display nat session verbose
Initiator:
Source IP/port: 202.38.1.25/53957
Destination IP/port: 202.38.1.1/21
DS-Lite tunnel peer: -
10.110.10.1/21
10.110.10.2/21
10.110.10.3/21
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
166
(Connections: 1)
(Connections: 2)
(Connections: 2)