Configuring Load Sharing Based On Bandwidth - HP FlexNetwork MSR2003 Configuration Manual

Configuring load sharing based on bandwidth

This feature load shares flow traffic among multiple output interfaces based on their load
percentages. The device calculates the load percentage for each output interface in terms of the
interface expected bandwidth.
Devices that run load sharing protocols, such as Locator/ID Separation Protocol (LISP), implement
load sharing based on the ratios defined by these protocols.
To configure load sharing based on bandwidth:
Step
1. Enter system view.
2. Enable IPv4 load sharing
based on bandwidth.
3. Enter interface view.
4. Configure the expected
bandwidth of the interface.
Command
system-view
bandwidth-based-sharing
interface interface-type
interface-number
bandwidth bandwidth
176
Remarks
N/A
By default, the IPv4 load sharing
based on bandwidth is disabled.
N/A
By default, the expected
bandwidth is the physical
bandwidth of the interface.