(2) Move and align carriage 1 with the cutout sec-
tion of the frame, then unhook the wire fixture
..... (each screws for the front and rear).
(3)
Remove the power supply cable from the car-
riage 2's cable guide.
(4)
Slanting the whole carriage 1 unit, take it out
upwards.
Note: Be careful not allow the unit to get hitched
by the wire.
7.3.8
Carriage drive wire
The same procedure applies for removing the front
and rear wires.
(1)
Remove the original glass, top cover, right-
side cover (upper), left-side cover (upper), in-
ner cover, and control panel.
(2)
Remove carriage 1 and the wire fixture
....... (each screw for the front and rear).
Note: Be careful not to get hitched by the wire.
Mar. 1998 © TOSHIBA
Cutout section
View as seen from the exit side
Cutout section
7 - 11
Cutout section
Carriage 1
Cutout section
Carriage 1
1550/1560 OPTICAL