Toshiba 1550 Service Manual page 200

(7) Push the hook located on each side of the
developer unit with your fingers in the di-
rection of the arrows to disengage them and
then remove the top cover.
(8) Pour in the developer material.
Note: Before pouring in the developer ma-
terial, be sure to shake the developer
bottle fully.
(9) By rotating the magnetic roller, check to
make sure that the developer material is
transported properly.
(10) Reinstall the top cover. The two hooks
should be securely latched.
Make sure that the top cover is securely
closed. Also, make sure that the rubber
seal of the top cover is positioned outside
of the side seals (both sides).
(11) After placing the developer unit in the proc-
ess unit, move down the lever on each side
by 90° to fix the developer unit. Be sure to
insert the connector securely.
(12) Reinstall the proccess unit into the machine
(1 screw).
Note: Be sure not to install the toner car-
tridge at this time.
1550/1560 UNPACKING PROCEDURE 18 - 4
Top cover
Mar. 1998 © TOSHIBA