Toshiba 1550 Service Manual page 28

(7) Remove the 2 screws of the bypass separation
pad bracket.
(8) Push down the pick-up roller and take out the
separation pad bracket by pushing down the
paper stop lever and the arm of the paper
sensor.
For the removal of the bypass paper feed roller,
the separation pad and the clutch, details are given
later.
(9) Remove the process unit, inner cover (upper)
and the control panel.
(10) Remove the paper-feed side gas spring (E-
ring, 1 piece). Then, open the original cover
to prevent the upper unit from falling down.
(11) Remove 1 screw of the paper guide and pull
it out toward the front. (two paper guides can
removed at the same time.)
(12) Remove the right cover.
(13) Remove the connector cover of the switch.
(14) Remove the 3 screws of the bracket fixing the
switch.
(15) Pull the bracket out with the harness
connected.
< For removing the lens motor, details are given
later. >
1550/1560 GENERAL
5. 1 (7)
[E-2] (7)
2 - 21
Paper stop lever
Paper stop lever
Pick-up roller
Pick-up r
<Illu
Separation pad
Separation pad
5. 1
[E-2] (11)
Pap
Paper guide
[E-2] (14)
5. 1 (14)
[E-2] (14)
5. 1 (14)
5. 1 (13)
[E-2] (13)
Connector cover
Connector cover
[E-2] (14)
5. 1 (14)
Mar. 1998 © TOSHIBA