2.4.2
Removal and installation of electrical parts
[A] Remove the control-panel (PWA-F-PNL) PC board
(1) Remove the control panel cover.
Refer to 2.4.1 [H].
(2) Place the control panel cover upside down and remove its metal cover (6 screws).
Remove the earth screw of the shield. Remove the counter connector.
(3) When you remove nine (9) screws, the control-panel PC board can be taken out along with the
harness. They can be separated if you disconnect two connectors.
Note: Be careful not to allow the ground wire of the shield to be cut.
Mar. 1998 © TOSHIBA
2 - 18
Earth screw
Connector
1550/1560 GENERAL