(3) Using the wire holder jig, fasten the wire on
the shaft, so that it does not loosen
....... at both front and rear.
Note: The front side wire can be identified by its
mark on the metal portion.
Front side wire : F
Rear side wire : R
(4) After having loosened the wire tension adjust-
ment screw, disengage the hook on the feed
side
....... for both front and rear.
(5) Remove carriage 2.
1550/1560 OPTICAL
View as seen from the feed side
7 - 12
Wire holder jig
Carriage drive wire
Hook
Carriage 2
Mar. 1998 © TOSHIBA