13.4.5
Drive motor and drive PC board
(1) Remove the rear cover.
Drive PC board:
(1) After disconnecting six connectors, remove the
PC board from its four lock supports.
Drive motor:
(1) Disconnect one connector from the drive PC
board.
(2) Remove four screws and take out the motor
assembly.
(3) Remove the bracket (2 screws).
(4) Remove three screws.
Note: When installing the motor assembly to the
rear frame, take the following precaution.
Tighten respective screws so that the front
edge of the damper should be down by 5~6
mm from the frame surface.
(Overtightening can damage the damper.)
Mar. 1998 © TOSHIBA
Drive motor
Damper
Motor assembly
13 - 13
Drive PC board
Bracket
Rear frame
Screw
1550/1560 OPTIONAL