Maintenance Schedule; Required Tools And Accessories; Outdoor Mobility Base; Rear Wheels - Otto Bock kimba neo Service Manual

All instructions concerning the adjustment of the parts installed are included in the Instructions for Use (qualified
personnel) – see the section "Foreword" for the order number.

3.3 Maintenance Schedule

Maintenance schedule as a template for copying: see Page 40.

3.4 Required Tools and Accessories

The following tools are required in order to perform the service work:
• Reversible ratchet handle wrench and sockets (size: 8 – 24)
• Torque wrench (measurement range 5 - 50 Nm)
• Wrench (size: 8 – 24)
• Allen wrench (size: 2.5 – 6)
• Screwdriver (blade width: 2.5/3.5/5 mm)
• Phillips head screwdriver (size: 2)
• Hammer (approx. 300 g); soft-faced hammer
• Pliers: cutting pliers, combination pliers, snap ring pliers
• Rivet gun (for rivets up to ø 5 mm)
• Pin punch, ø 3/4/5/6 mm
• Drill/twist drill ø 3.2/5/5.2/6 mm
• Stanley knife with sickle hooked blade and standard blade
• Tyre mounting levers and inner tube repair kit*
• Workbench and vice with plastic jaws and rubber insert
• Measurement equipment: rule, spirit level
• Liquid thread locker, "medium" and "strong"
1)
Included in 481C08=ST010 Tool Set
2)
Size 3 – 6 contained in the 481C08=ST010 Tool Set

3.5 Outdoor Mobility Base

3.5.1 Rear Wheels

3.5.1.1 Replacing the Rear Wheel

1) Release the wheel lock.
2) Press down the lock on the rear wheels (see Fig. 4).
3) Replace and reinstall the wheel. The locking mechanism must engage audibly.

3.5.1.2 Replacing the Casing

Replacing the casing on the rear wheel (see Fig. 6, Pos. 1) corresponds to replacing the casing on the caster
wheel: see Page 11.

3.5.1.3 Replacing the Tube (Pneumatic Tyre)

Replacing the tube on the rear wheel (see Fig. 6, Pos. 2) corresponds to replacing the tube on the caster wheel:
see Page 12.
Kimba neo
1)
2)
4
Service Work
5
Ottobock | 9