Back; Replacing The Back Insert - Otto Bock kimba neo Service Manual

Service Work
4) Twist the hook-and-loop strap down and push the frame padding over the folding mechanism all the way to the
release handles (see Fig. 76).

3.6.2 Back

3.6.2.1 Replacing the Back Insert

INFORMATION
The manufacturer offers two versions of the back insert:
► Standard back insert: see Fig. 78
► Back insert with head supports: see Fig. 79
1) Remove the backrest pad (see Page 24).
2) Loosen the 2 x set screws on the backrest tubes (see Fig. 77, Pos. 1).
3) Remove and replace the standard back insert (see Fig. 78) or the back insert with head supports (see Fig. 79).
4) Slide the new back insert into the back frame and adjust it to the desired height.
5) Tighten the set screws (see Fig. 77, Pos. 1).
INFORMATION: You can achieve a greater back height by additionally shifting the top back plate at
the back insert. To do so, loosen/remove the knurled nuts, shift the back plate and hand-tighten the
knurled nuts again.
6) Put the backrest pad in place (see Page 24).
Adapting the Back Insert with Integrated Head Supports
To adjust the clearance in the area of the head, up to 3 foam pads with a thickness of 1 cm each can be glued onto
the head supports (see Fig. 80, Pos. 1). They are included with the backrest pad.
26 | Ottobock
76
77 78
Kimba neo